P96/R215

Molding machine for bra cups in fabric

Two molds with adjustable distance between the molds and rotary table

Maximum mold diameter 215 mm (8" 1/2)

AMP PISANI innovative molding system in a heated upper bell and male mold rising from underneath the fabric support base.

Significantly higher molding quality than conventional systems.

The molding time is much shorter, and energy savings can be as high as 80% compared with conventional systems.

Rotary table with one loading/unloading area and one molding area on the opposite side.

The operator positions the material on the loading/unloading area while the machine is molding the pieces on the opposite area.

The molding cycle consists of the descent from the top of a heated bell on the fabric then the mold underneath move upwards

The normal molding cycle time is from 20 to 50 sec depending of the type of material.

The total cycle time is about the same of the molding time as the machine does not wait for the positioning of the pieces.

Adjustable distance between the molds from 15 mm to 270 mm.

Upper and lower plates supplied for any distance between the molds (within the range from 15 mm to 270 mm).

Very fast adjustment of the molding depth on a ruler.

Time to change both molds is 3 min. No need to do any electrical connection.

If the replaced molds have been preheated, the machine is ready to operate

Each setting of temperature and times are adjustable with digital timers and thermoregulators.

Machine equipped with PLC and operator terminal to set machine datas and display alarm messages.